Megaware KeelGuard developed the industry's first
patented, do-it-yourself keel protector in 1992 and has
been providing boat owners with the highest quality
protection products ever since.
Save your boat or personal water craft
from grinding sand, abrasive rocks and concrete ramps.
Each Megaware KeelGuard
product comes with Easy Instructions,
and No Special Tools are required. You
can Do It Yourself or have your dealer
install it for you.
Protect against abrasive sand,
rocks, concrete ramps and oyster beds
Eliminate costly repairs
Enjoy the highest quality and
superior engineering
Increase the value of your
boat
Wear and damage to your boat’s
keel can break down its protective gelcoat finish,
allowing water to reach and destroy the fiberglass
laminates.
Lengths & Colors
Megaware KeelGuard comes in 14 great looking
colors to match virtually any boat or PWC. All colors are
UV-stabilized for true color that lasts a lifetime.
Keel Guard is available in nine standard lengths or can be
ordered in custom sizes.
We carry in stock White, Black, Almond and Gray in
two sizes 6 & 8'
KeelGuard Size
Boat Length
6 ft
17 to 18 ft
7 ft
19 to 20 ft
8 ft
21 to 22 ft
We carry in stock White, Black, and Gray in
two sizes 6 & 8'
6' $119.00
Keelguard 6 foot Price: $119.00 Shipping: $16.95
8' $140.00
Keelguard 8 foot Price: $140.00 Shipping: $16.95
7' $130.00
Keelguard 7 Foot Price: $130.00 Shipping: $16.95
Megaware KeelGuard
The KeelGuard is a very simple product to
install; however, the following instructions must be strictly
followed. Any short cuts or missed steps will jeopardize and
compromise the full bonding capabilities of the 3M adhesive. For
best results the Keel Guard should be installed at an ambient
temperature of 60º or above.
Typically, the Keel Guard is mounted 4 to 6
inches above the waterline on the bow, ending 2 to 3 feet or
more beyond the lowest point of the Keel. If protection is
required above the Boweye, a separate Bow Guard is available in
1ft to 3ft lengths. For personal watercraft, begin the
Megaware KeelGuard
approximately 1 inch below the bow hook, running the length of
the keel, and ending 4 to 6 inches forward of the pump intake.
Application Kit Included
Note:
If your trailer is designed such that the entire weight of the
boat rests on rollers or a support beam along the keel, we do
not recommend installing the KeelGuard. If the rollers can
be lowered or the side bunks raised to clear the rollers, the
KeelGuard adhesive bond will not be compromised.
Application may not be suitable for some aluminum boats with
reinforced rib design. Please contact Megaware KeelGuard
for your particular application.
Megaware KeelGuard developed the industry's first
patented, do-it-yourself keel protector in 1992 and has
been providing boat owners with the highest quality
protection products ever since. 
